Chapter 8 Wideband testing
Performing WBTIMS measurements
Viewing a saved
spectral analysis
trace
88
9
Optional. To superimpose a spectral mask for a specific
technology, do the following:
a Press the Display soft key and then press 7.
NOTE:
The Spectral Mask selection is only available on spans
1.9 MHz and higher.
b Select a technology.
Spectral mask
10 Optional. To change the scale of the y-axis, do the
following:
a Press the Actions soft key.
b Select a scale: Switch to dBm or Switch to dBm/Hz.
11 Press the Results soft key to save the results, if desired.
For information about saving your results in graphical
form, see
"Saving results" on page
12 Press the Stop soft key.
Spectral analysis is complete.
The following procedure describes how to view a saved trace.
To view a saved trace
1
Press the Results soft key.
2
Press 2 to Load Reference Trace.
HST-3000 Copper Testing User's Guide
167.