Testing Voice Service And Caller Id - JDS Uniphase HST-3000 User Manual

Chapter 7 Testing voice service

Testing voice service and Caller ID

Testing voice service and Caller ID
72
The POTS dialer allows you to place and receive voice calls
to verify that the service is working properly. You can also use
the dialer for the following tasks:
– to drop battery for opens testing
– to establish a quiet termination for balance and noise
tests
– to determine if loss at 1004 Hz is acceptable
– to test incoming caller ID number and name
The following procedure describes how to test voice service
and caller ID.
To test voice service and caller ID
1 Connect the Tip (A), Ring (B), and Ground (Earth) leads
to the line under test.
2 Access the Copper Measurements menu (see
3 Press the 7 key.
The POTS Phone menu appears.
4 Place a call.
a Dial the number using the speed-dial (Speed soft key)
or manually enter the phone number using the keypad.
HST-3000 Copper Testing User's Guide
page 8).