Transmitting Wideband2 Tones - JDS Uniphase HST-3000 User Manual

Transmitting
wideband2 tones
The following procedure describes how to transmit wideband2
tones.
To transmit wideband2 tones
1 Connect the Tip (A), Ring (B), and Ground (Earth) leads
to the line under test, as described in
line" on page
2 Press the Actions soft key.
3 Press the 2 key to transmit tones.
4 Select the tone to transmit.
To transmit ...
standard tone
custom tone
5 Press the Start soft key.
The tone graph appears.
NOTE:
Your display may look different, depending on your trans-
mission selection.
HST-3000 Copper Testing User's Guide
113.
Do this...
Select a frequency
Press the 8 key
A Tx Frequency field appears. Enter a
value for the frequency (kHz).
Chapter 8 Wideband testing
Performing WB2 measurements
"Connecting to the
119