Wimax Authentication; Viewing The Cpe Authentication Method - Siemens RUGGEDCOM WiN5200 User Manual

Chapter 6
CPE Management Interface
• the base station bandwidth
• the transmission preamble
• the CINR R1 value
• the RSSI value, in dBm
6.
To add an entry to the Scanner Table, click the
32 rows to the table.
Set the values for the new scanning range in the Priority, Bandwidth [MHz], Start frequency [kHz], Step
[kHz], and End frequency [kHz] fields.
7.
To remove a row from the table, select the row and click the
8. After adding or editing rows in the Scan Report table, or after changing the values in the Autoconnect
CINR threshold or Connect to recent used BS fields, click the Apply button.
9. To begin scanning for base stations, click the Connect button.
10. To stop scanning for base stations, click the Disconnect button.
11. To delete all scanning configuration information, click the Delete All button.
Section 6.5.2

WiMAX Authentication

On the the Authentication panes, you set view and set the WiMAX authentication parameters. The CPE
supports EAP-TLS (Extensible Authentication Protocol - Transport Layer Security) and EAP-TTLS (Extensible
Authentication Protocol - Tunneled Transport Layer Security) authentication. You can also set the CPE to use null
(no) authentication.
This section describes how to:
• view the current CPE authentication setting. See
• configure EAP-TLS authentication. See
• configure EAP-TLLS authentication. See
• configure null authentication. See
• view the authentication certificate filenames. See
Section 6.5.2.1

Viewing the CPE Authentication Method

The Authentication Setting pane displays the current CPE WiMAX authentication configuration. The
Authentication Setting pane is read-only; there are no parameters to set on this pane.
Procedure: Viewing CPE Authentication
1. Click the WiMAX button. The Scanner Settings pane appears.
2. In the options panel, click the Authentication link. The Authentication Method pane appears.
3. On the Authentication Method pane, click the Show Settings button. The Authentication Setting pane
appears.
88
button. A new row appears in the table. You can add up to
Section 6.5.2.1, "Viewing the CPE Authentication
Section 6.5.2.2, "Configuring EAP-TLS
Section 6.5.2.3, "Configuring EAP-TTLS
Section 6.5.2.4, "Configuring Null
Section 6.5.2.5, "Loading Authentication
button. The row is removed from the table.
Authentication".
Authentication".
Authentication".
RUGGEDCOM WiN5100/WiN5200
User Guide
Method".
Certificates".
WiMAX Authentication