Siemens RUGGEDCOM WiN5200 User Manual page 78

Chapter 6
CPE Management Interface
Table: Traps Table
Column
Trap ID
Trap Name
Activation Mode
Severity
Category
Description
Value
4. Click the Apply button.
For testing purposes, you can send selected traps on demand. To send traps, you must have SNMP Trap
Destinations configured. For instructions on configuring SNMP Trap Destinations, see
Administration".
Procedure: Sending SNMP traps on demand
1. In the Traps Table, select one or more SNMP traps.
2. Click the Send Trap button.
SNMP Traps List
NOTE
The WIMAX-SS-TRAPS.mib file in the software release folder contains a full list of traps.
Table: SNMP Traps List
70
Description
Displays the trap identification number.
Displays the trap name.
Indicates if the trap is enabled or disabled. To enable a trap, select True. To disable a
trap, select False.
Values: True | False
Displays the severity of the trap condition.
Values: Clear | Critical | Major | Warning
Displays the category of the trap condition.
Values: Restart | Communication | RF | Hardware | Security | Environmental |
Redundancy | Services | Link Status
Displays a description of the trap condition.
Displays the value reported by the SNMP trap.
Event Name
RestartOK
RestartFailure
WebLoginOK
WebLogout
WebLoginFailed
EthernetUp
EthernetDown
FileOperationsOK
FileOperationsFail
ConfigChanged
Section 6.2.9, "SNMP
Description
The subscriber station restarted successfully.
The subscriber station failed to restart. This
event reports all causes of initialization errors.
Web interface login was successful.
Web interface logout.
Web login has failed for 10 consecutive attempts.
Ethernet link is up.
Ethernet link is down.
File operations are successful.
File operations failed.
Configuration was changed successfully.
RUGGEDCOM WiN5100/WiN5200
User Guide
Alarms & Traps