RUGGEDCOM WiN5100/WiN5200
User Guide
Section 6.2.11
NTP Server
Use the NTP Server pane to access the NTP server.
NOTE
Prior to enabling the NTP server, the Time Advertisement Enabled field must be set, on the GPS
pane in the base station. This field enables the NTP Server to work properly.
Procedure: Accessing the NTP Server
1.
Click the Management button. The Management options appear in the options pane.
In the options panel, click the NTP Server link. The NTP Server pane appears.
2.
Figure 61: NTP Server pane
3.
Review and set the parameters in the following fields:
Table: NTP Server table
Field
Enable Ntp Server
NTP Server
Event Name
DuplicateNsiIp
DuplicateRfiIp
CPELocked
CPEUnlocked
ACLPacketDrop
Description
To set the NTP Server, select a value from this list.
Values: True | False
Description
Duplicate LAN IP address.
Duplicate RF IP address.
The CPE Ethernet port is locked to forward user data.
Only management data is permitted from the LAN.
The CPE Ethernet port is unlocked to forward user data.
If the maximum permitted number of access list
entries is exceeded, packets from any new host will
be dropped. In addition to a trap being sent at the
occurence, the trap will be sent every 1000 packets.
Chapter 6
CPE Management Interface
71