Table of Contents
Advertisement
RUGGEDCOM WiN5100/WiN5200
User Guide
5.
Refer to
Figure
• Loop the drain wire over the prepared grounding shield of the RJ45.
• Solder in position and trim off the remaining drain wire.
Figure 25: Solder the Drain Wire
6.
Refer to
Figure
• Insert the modular plug into the plug housing.
• Align the latch with the LATCH slot.
• Press the modular plug into the plug housing until it bottoms out.
Figure 26: Assembly of Connector Components
7.
Refer to
Figure
tighten the compression nut to 0.56Nm (5 In-lbs).
Figure 27: Connecting the Cable to the CPE
Assembling the RJ45 Connector
25.
26.
27. While maintaining inward pressure on the plug or keeping the dust cover engaged,
Chapter 4
Installation Procedure
33
- Quick Links:
- Connecting to and Logging in to...
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the RUGGEDCOM WiN5200 and is the answer not in the manual?
Questions and answers