Snmpv2 Configuration - Siemens RUGGEDCOM WiN5200 User Manual

RUGGEDCOM WiN5100/WiN5200
User Guide
Figure 54: SNMP General Settings
3. In the SNMPv2c and SNMPv3 fields, enable or disable SNMPv2c and SNMPv3.
4. In the Managers Table, add up to five trap destination addresses:
a.
Click the
b. Type an IP address in the new row.
5.
To remove an SNMP trap destination, select a row and click the
button removes the last entry in the table.
6. Click the Apply button.
7. To configure SNMPv2 parameters, click the SNMPv2 Configuration button. See
Configuration".
8. To configure SNMPv3 parameters, click the SMPv3 Configuration button. See
Configuration".
Section 6.2.9.2

SNMPv2 Configuration

The SNMPv2c Configuration pane appears when you click the SNMPv2 Configuration button on the SNMP
General Settings pane. On this pane, you set the SNMPv2c read, write, and trap community settings.
Procedure: Setting the SNMPv2c parameters
1. On the SNMP General Settings pane, click the SNMPv2 Configuration button. The SNMPv2c
Configuration pane appears.
SNMPv2 Configuration
button. A new row appears in the Managers Table.
CPE Management Interface
button. If no rows are selected, clicking the
Section 6.2.9.2, "SNMPv2
Section 6.2.9.3, "SNMPv3
Chapter 6
63