Snmpv3 Configuration - Siemens RUGGEDCOM WiN5200 User Manual

Chapter 6
CPE Management Interface
Figure 55: SNMPv2c Configuration pane
2. The Current SNMPv2 Status field displays the current status for the SNMPv2 system: Enabled or Disabled.
3. Review and set the SNMPv2c settings in the following fields:
Table: SNMPv2c Configuration table
Field
SNMP Read Community
SNMP Write Community
SNMP Trap Community
4. Click the Apply button.
Section 6.2.9.3

SNMPv3 Configuration

The SNMPv3 Configuration pane appears when you click the SMPv3 Configuration button on the SNMP
General Settings pane. On this pane, you configure SNMPv3 users, authentication parameters, and access
groups.
Procedure: Setting the SNMPv3 parameters
1. On the SNMP General Settings pane, click the SNMPv3 Configuration button. The SNMPv3
Configuration pane appears.
64
Description
The SNMP community name for read access. This name can be used as a password
for secure information retrieval. Type a name in the field. The SNMP Read Community
name must be different from the SNMP Write Community name.
Default: public
The SNMP community name for write access. This name can be used as a password
for secure set commands. Type a name in the field. The SNMP Write Community name
must be different from the SNMP Read Community name.
Default: private
The SNMP community name to use when the SNMP service receives a request that
does not contain the correct community name and does not match an accepted host
name.
Default: public
RUGGEDCOM WiN5100/WiN5200
User Guide
SNMPv3 Configuration