Installing The Win1010 Data Adaptor - Siemens RUGGEDCOM WiN5200 User Manual

Chapter 4
Installation Procedure
Section 4.10.3

Installing the WiN1010 Data Adaptor

The WiN1010 data adaptor powers the ODU CPE and distributes data. The WiN1010 data adaptor unit provides
RJ-45 input connectors that include 10/100Base-T transformers for connection to an IEEE802.3 (10/100Base-
T) compatible device. The unit receives power from 100V to 240V AC using an IEC-320-C14 industry standard
connector.
CAUTION!
Important:
The power supply AC cord should be 3 wires, 18 AWG minimum, with length less than 4.5 m, and
safety certified according to national rules.
A single output RJ-45 connector provides 10/100 Base-T data and power to the outdoor unit over a
Category 5e cable. This cable provides for the bi-directional transfer of data and signalling as well as a
power feed to the outdoor equipment.
NOTE
The Category 5e Ethernet cable is not included. Refer to
for detailed technical specifications.
Figure 28: Power over Ethernet Connection Schematic
NOTE
Before connecting the WiN1010 data adaptor to the 110 VAC/220 VAC power source, verify that all
system components are properly installed. Make sure that all cable connectors are securely positioned
in the appropriate ports.
Procedure: Connecting Power to the CPE
1. Connect a Category 5e cable between the CPE and the WiN1010 data adaptor.
2. Connect a Category 5e cable between the WiN1010 data adaptor and a 10/100 Base-T port of a switch,
router, or PC.
34
Appendix B, IDU to ODU Cable Specifications
Installing the WiN1010 Data Adaptor
RUGGEDCOM WiN5100/WiN5200
User Guide