Configuring Dscp Marking - Siemens RUGGEDCOM WiN5200 User Manual

RUGGEDCOM WiN5100/WiN5200
User Guide
Figure 47: Management VLAN pane
3. Review and set the management VLAN parameters in the following fields:
Table: Management VLAN Fields
Field
VLAN Number
802.1p bits [0-7]
4. Click the Apply button.
Section 6.2.7.3

Configuring DSCP Marking

On the DSCP Marking pane, you configure the Differentiated Services Code Point marking value. DSCP marking
identified outgoing management traffic only.
Procedure: Setting the DSCP Marking Parameter
Click the Management button. The System Functions pane appears.
1.
2. In the options panel, click the Remote Management link, and then click the DSCP Marking link. The DSCP
Marking pane appears.
Configuring DSCP Marking
Description
Displays an identifier for the management VLAN. When setting this value, ensure that
the relevant VLAN service is created on the base station and that remote management
is enabled.
Values: Any numeric value
Default: 0
Sets the 802.1p priority value for the management VLAN. Type a value from 0 to 7.
Values: A number in the range of 0 to 7
Default: 6
Chapter 6
CPE Management Interface
53