Snmp Administration; Snmp General Settings - Siemens RUGGEDCOM WiN5200 User Manual

Chapter 6
CPE Management Interface
Field
5. To cancel a download or upload operation that is currently in progress:
• Click the Cancel button.
Section 6.2.9

SNMP Administration

In SNMP administration, you enable and disable SNMPv2 and SNMPv3, configure trap destinations, SNMP
communities, and MIB2 system identification parameters.
For instructions on enabling and disabling SNMPv2 and SNMPv3, and on setting SNMP trap destinations, see
Section 6.2.9.1, "SNMP General
For instructions on configuring SNMPv2, see
For instructions on configuring SNMPv3, see
For instructions on setting the MIB2 system identification information, see
Section 6.2.9.1

SNMP General Settings

On the SNMP General Settings pane, you can enable or disable SNMPv2 and SNMPv3, set the SNMP trap
destinations, and access the SNMPv2 and SNMPv3 configuration settings. You can specify up to five trap
destination addresses.
Procedure: Setting the SNMP general settings
1. Click the Admin button. The Admin options appear in the options pane.
2. In the options pane, click the SNMP link, and then click the SNMP General Settings link. The SNMP
General Settings pane appears.
62
Description
Values: OK | Not Started | In Process | Failure
Settings".
Section 6.2.9.2, "SNMPv2
Section 6.2.9.3, "SNMPv3
RUGGEDCOM WiN5100/WiN5200
Configuration".
Configuration".
Section 6.2.9.5, "MIB2
SNMP Administration
User Guide
System".