Changing The Cpe Management Interface Password - Siemens RUGGEDCOM WiN5200 User Manual

RUGGEDCOM WiN5100/WiN5200
User Guide
• Disconnect the CPE from the base station: To stop broadcasting and disconnect from the base station,
click the Disconnect button.
• Reboot the CPE: To reboot the CPE and run the software in the "Primary" memory bank, click the Reboot
button.
• Log out of the management interface: To log out of the CPE management interface, click the Logout
button.
• Restore the CPE to factory defaults: To restore the CPE to its factory default settings and reboot the
CPE, click the Set Factory Defaults button.
• Partially Restore the CPE to factory defaults: To restore the CPE to its factory default settings, except
for parameters that affect CPE connectivity, and reboot the CPE, click the Set Partial Defaults button.
Section 6.2.2

Changing the CPE Management Interface Password

The Change Password for User Admin pane appears when you click the Change Password button on the
System Functions pane. On this pane, you can change the the CPE management interface password for the user
admin.
Procedure: Changing the Admin Password
1. Click the Management button. The System Functions pane appears.
Click the Change Password button. The Change Password for User Admin pane appears.
2.
Figure 41: Change Password for User Admin pane
In the Current Password field, type the current password. The default password is generic.
3.
4. In the New Password field, type the new password.
5. In the Confirm Password field, retype the new password.
6. Click the Apply button.
Changing the CPE Management Interface Password
Chapter 6
CPE Management Interface
47