Configuring The Cpe - Siemens RUGGEDCOM WiN5200 User Manual

RUGGEDCOM WiN5100/WiN5200
User Guide
NOTE
The default user name is admin and the default password is generic. The user name and
password are case sensitive.
Section 5.2

Configuring the CPE

This section describes how to configure the initial CPE settings. This section describes just the minimal setting
required to connect the CPE to the network. After installing the minimally configured CPE, configure additional
parameters remotely through the wireless link.
Procedure: Configuring the WiN5100/WiN5200
1. Connect a computer to the CPE and log in to the CPE management interface. For instructions, see
Section 5.1, "Connecting to and Logging In to the
Click the WiMAX button. The Scanner Settings pane appears.
2.
Figure 34: Scanner Settings pane
3. Review the entries in the Scanner Table and ensure that the CPE is configured to work in the correct
frequency.
4.
To add an entry to the Scanner Table, click the
32 rows to the table.
Configure the bandwidth and frequency settings in the following fields:
Configuring the CPE
Equipment Configuration and Monitoring
CPE".
button. A new row appears in the table. You can add up to
Chapter 5
39