Table of Contents
Advertisement
Chapter 4
Installation Procedure
NOTE
When mounting a WiN5258 or WiN5249 unit, make sure that the antenna and CPE unit are rotated by
45 degrees (when compared to other models), with the arrow on the antenna facing up, as shown in
the following figure.
Figure 14: Mounting a WiN5258 or 5249 Unit
Procedure: Mounting the CPE Unit To a Wall
1.
Select a mounting location on the wall.
2.
Place the mounting bracket on the wall and mark 4 mounting holes.
3.
Drill 4 holes and insert 4 type NC 1/4" fastening inserts into the holes.
4.
Secure the mounting bracket to the wall with 4 type NS 1/4" × 1/2" HEX screws, 4 spring washers, and 4 flat
washers.
5.
Connect the arm bracket to the mounting bracket using a screw, spring washer and washer. Make sure the
screw is hand tightened.
6.
Connect the CPE unit to the arm bracket using a screw, spring washer and washer. Make sure the screw is
hand tightened.
7.
Adjust the position of the CPE unit. For more information about how to aligned the CPE Antenna, refer to
Section 4.9, "Aligning the CPE
26
Antenna".
RUGGEDCOM WiN5100/WiN5200
User Guide
Wall Mount Installation
- Quick Links:
- Connecting to and Logging in to...
Hide quick links:
Advertisement
Table of Contents
