Siemens RUGGEDCOM WiN5200 User Manual page 77

RUGGEDCOM WiN5100/WiN5200
User Guide
Column
Severity
Category
Last Description
Last Update Time
SNMP Trap Settings
On the SNMP Trap Settings panel, configure the subscriber station SNMP traps. From this pane, you can also
select traps and send them on demand.
NOTE
To send traps, you must have SNMP Trap Destinations configured. For instructions on configuring
SNMP Trap Destinations, see
Procedure: Setting SNMP traps
1. Click the Management button. The Management options appear in the options pane.
2. In the options panel, click the Alarms and Traps link, and then click the Traps link. The SNMP Trap
Settings pane appears.
Figure 60: SNMP Trap Settings
3. In the Traps Table, review and configure the SNMP traps:
Alarms & Traps
Description
Values: Off | On
Displays the severity of the alarm.
Values: Clear | Critical | Major | Warning
Displays the category for the alarm type.
Values: Restart | Communication | RF | Hardware | Security | Environmental |
Redundancy | Services | Link Status
Displays a message describing the alarm.
Displays the date and time of the most recent alarm.
Section 6.2.9, "SNMP Administration"
Chapter 6
CPE Management Interface
69