Siemens RUGGEDCOM WiN5200 User Manual page 83

RUGGEDCOM WiN5100/WiN5200
User Guide
• Use the LAN IP address when you access the CPE through a direct connection to its physical Ethernet port.
• Use the RF IP address when you access the CPE through the RF network.
Procedure: Configuring the IP Settings
1. Click the Network button. The IP Settings pane appears.
Figure 65: IP Settings pane
2. View and configure the LAN and RF IP settings in the following fields:
Table: IP Settings fields
Field
Current LAN IP Address
Configured LAN IP Address
Current LAN Mask
Configured LAN Mask
RF IP mode
RF IP Address
RF IP Subnet Mask
RF IP Default Gateway
3. Click the Apply button.
4. If you changed the value in the Configured LAN IP Address or Configured LAN Mask fields, reboot the
base station:
a. Click the Management button. The System Functions pane appears.
b. Click the Reboot button. The CPE reboots.
Network IP Settings
Description
Displays the currently configured CPE LAN IP address.
To change the LAN IP address, type an IPv4 address in this field. After changing this
field, you must reboot the CPE.
Displays the currently configured LAN netmask.
To change the LAN mask, type a dotted-decimal mask in this field. After changing this
field, you must reboot the CPE.
Displays the RF IP mode: Static or DHCP. To change the mode, select a value from the
list.
Displays the RF IP address. To change the address, type an IPv4 address in this field.
Displays the RF IP subnet mask. To change the subnet mask, type a dotted-decimal
mask in this field.
Displays the RF default gateway. To change the gateway, type an IPv4 address in this
field.
Chapter 6
CPE Management Interface
75