Combustion Blower Removal
Make sure the stove has fully cooled (approximately 25 minutes) before conducting service. Unplug the
stove to prevent electrical shock.
1. Remove the left side panel (see section "Side Panel Removal").
2. Locate the combustion blower just inside the side opening of the stove, beside the exhaust plenum (see below)
3. Locate the two wires that power the fan motor. Disconnect the wires from the motor. Make sure not to damage
the connectors on the wires while removing.
4. Use a ¼" nut driver to remove the screws that secure the access plate at the bottom, rear of the stove as shown
below (set aside for reinstallation).
Combustion Blower
17602010 - 12/15/17
Page 41