Models Addressed In This Guide; Who Should Use This Guide; Precautions; Items To Bring On Service Calls - Travis Industries Deerfield Service & Troubleshooting Manual

Models Addressed in this Guide

This guide addresses the Lopi Deerfield™ and Foxfire™ Stoves.

Who should use this guide

This guide was developed for service personnel and those selling Travis Industries products. Because of the inherent
danger involved with heating appliances, all work must be done by qualified personnel only. The heater must be
installed in accordance with the owner's manual and all local building codes. Bring an owner's manual for the heater
being serviced in case any installation or maintenance questions arise.

Precautions

This heater becomes very hot during operation - use care to prevent burns or property damage while
servicing.
Make sure the appliance is unplugged before conducting service or replacing a component. Some
procedures may require the heater to be plugged in while diagnosing the problem. In these cases, use
caution to prevent arcing or electrical shocks.
Before conducting service, lay down a drop cloth to prevent fly ash and other debris from staining the
carpet or other flooring. On inserts, lay down a piece of cardboard on the hearth to prevent scratches.

Items to Bring on Service Calls

Tools

• Nut drivers
• open end & socket wrenches in 1/4", 5/16", 11/32", 3/8", 7/16", 1/2", 7/8", 1"
• Allen Wrenches
• Torx bits or drivers
• Multimeter
• Standard and Phillips-head Screwdrivers
• Wire with a male quick-connect attached to each end (called a jumper wire)
• Power cord with female quick-connects attached to the hot and common wires (called a hot wire)
• Ash Vacuum (or shop vacuum with drywall filter) and bottle brush for cleaning the stove
• Lock Ties (for keeping all wires from contacting hot portions of the stove)
• Cleaner, paper towels, drop cloth, cardboard & other supplies to clean any fly ash entering home.

Spare Parts

• Circuit Board
• Metering Auger Motor
• Push Auger Motor
• Exhaust Blower
• Snap Disks (System & Hopper)
• Combustion Blower & Blower Gasket
• Convection Blower
Test Cord
17602010 - 12/15/17
• Heater Fuses (5 Amp Fast Acing - 1/4" x 1-1/4")
• Circuit Board Fuses (6 Amp 5 mm x 20 mm)
• Door Gasket and Gasket Cement
• Igniter
• Flow Switch
Page 3
Jumper Wire