Power Control Board (PCB) Removal
Unplug the stove to prevent electrical shock.
1. Remove the rear panel (see section "Rear Panel Removal").
2. Gently pull the PCB away from the metal shield that surrounds it to gain access to the back of the board. You
may need to assist some of the wire harnesses through the shield behind the board. The board is held in
place by a clip in each corner. .
3. Press the (2) tabs on the sides of the 10 pin Molex plug (supplies AC power to the PCB) and disconnect it from
the board.
17602010 - 12/15/17
Pull forward to
disengage the
PCB from clips.
Page 12