Chisel Removal
Make sure the stove has fully cooled (approximately 25 minutes) before conducting service. Unplug the
stove to prevent electrical shock.
1. Remove all pellets from the hopper.
2. Using a ¼" nut driver remove the (6) ¼" screws that secure the HRD access panel to the hopper (set aside
for reinstallation).
3. Remove the HRD access panel. This will expose the top of the HRD assembly.
NOTE: You may want to use gloves when removing the plate to protect yourself from sharp edges.
17602010 - 12/15/17
Page 26