Travis Industries Deerfield Service & Troubleshooting Manual page 22

6. Remove the (3) 5/16" screws along the top and (3) additional screws along the bottom of the back panel. Lift up
on the panel using the handle on the top edge to disengage the bottom of the panel from the floor of the stove. Set
the screws aside for reinstallation.
7. Locate the two wires that power the fan motor (orange and grey). Disconnect the wires from the motor. Make sure
not to damage the connectors on the wires while removing.
8. The exhaust box is now loose in the stove. Lift the box up and gently remove it from the stove.
NOTE: It is a tight fit for the fan motor to fit between the push auger motor and the stove but it will fit. If you prefer,
you can remove the push auger motor to allow more room.
17602010 - 12/15/17
Page 22
Air Box