User Interface (UI) Removal
Make sure the stove has fully cooled (approximately 25 minutes) before conducting service. Unplug the
stove to prevent electrical shock.
7. Remove the left side panel (see section "Side Panel Removal") or the rear panel on a Deerfield (see section "Rear
Panel Removal").
8. Pull the PCB forward to release it from the shield (see "PCB removal").
9. Disconnect the AC power harness from the upper left corner of the board so you can tilt the board forward and
gain access to the back of it.
10. Disconnect the UI board harness from the back of the DCB.
11. Remove the rubber grommet where the harness enters the hopper, on the back side of the stove behind the left
hopper door hinge (set aside for re-installation).
Remove Rubber
Grommet
17602010 - 12/15/17
Page 46