Adjusting The Blower Speed; Normal Operating Sounds - Travis Industries Avalon Owner's Manual

Adjusting the Blower Speed

The blower helps transfer heat from the heater into the room. It will not turn on until the heater is up to
temperature (approximately 10 minutes after starting). See the illustration below for instructions on
adjusting the blower speed.
OFF
Turn the dial all the
way counter-clockwise
until it clicks off.

Normal Operating Sounds

Pilot Flame
The pilot flame,
which remains on,
makes a very slight
"whisper" sound.
Gas Control Valve
As the gas control valve is turned
on and off you will hear a dull
clicking sound. This is the valve
opening up and shutting down.
Travis Industries
Operation
HIGH
The high position is all the
way counter-clockwise,
without clicking off.
9 3 5 0 8 1 2 2
LOW
Turn the dial all the
way clockwise.
Blower
This heater uses a blower to
push heated air into the room.
You will hear the sound of air
movement that increases as
the speed is increased.
The appliance may
creak with change of
temperature.
Blower Snap Disk
This part can
produce a clicking
sound as it turns the
blower on and off.
1 4 1 1 0 0
23