Flow Switch Removal
Make sure the stove has fully cooled (approximately 25 minutes) before conducting service. Unplug the
stove to prevent electrical shock.
1. Remove the left side panel of the stove (see section "Side Panel Removal").
2. The Flow Switch is located behind the PCB. Removal of the PCB is not required but its removal will give
better access to the Flow Switch (see section "PCB Removal").
Use a 3/8" nut driver to remove the two locknuts that mount the switch to the rear panel of the stove (set
3.
aside for reinstallation).
4. Disconnect the two wires from the wiring harness at the quick connects (orientation does not matter for
reinstallation).
17602010 - 12/15/17
Page 43