Front Panel; Front Panel Operations; Creating A Tie; Viewing Ties (And Muting Outputs) - Extron electronics DMS 1600 Setup Manual

Front Panel

CONTROL
CONFIG ESC
ENTER PRESET VIEW
PRIMARY
REDUNDANT
POWER SUPPLY
TMDS DIGITAL MATRIX SWITCHER
9 10
Figure 6. Front Panel Features
i
Configuration port — If desired, connect a control system or
computer to the front panel Configuration port, a mini USB B
.
port
j
Primary and Redundant Power Supply LEDs —
NOTE: The meaning of these indicators is identical to the
LEDs on the power supplies (item
Green — Indicates that the associated power supply is operating
within normal tolerances.
Red — Indicates that the associated power supply is operating
outside the normal tolerances or has failed. See Maintenance and
Modifications to replace the power supply.
8 DMS 1600 and DMS 3600 • Installation
DMS 1600
g
).

Front Panel Operations

This section describes simple DMS matrix switcher operation from the
front panel. Topics that are covered include:
•

Creating a Tie

•

Viewing Ties (and Muting Outputs)

• Saving or Recalling a Preset
• Locking Out the Front Panel (Executive Mode)
Creating a Tie
1.
Press and release the Esc button to clear any input button, output
button, or control button indicators that may be lit.
2. Press and release the desired input button.
The button lights to indicate the selection.
5
3.
Press and release the desired output buttons.
The output buttons blink to indicate the potential ties.
3 4 8
The Enter button blinks to indicate
the need to confirm the change.
4. Press and release the Enter button. All button indicators turn off.
See figure 2 in the Installation section. The input numbers supported
by the I/O board in location 5 through 8 are as follows: A = 5, B = 6,
C = 7, D = 8.)
Viewing Ties (and Muting Outputs)
1. Press the View button. Output buttons light for outputs that have
no ties established.
NOTE: If an output button blinks, that output is muted. To
toggle mute on and off, press and hold the output
button for 2 seconds.
2. Press an input button. The buttons for all tied outputs light.
3. Press an output button. The buttons for the tied input and all tied
outputs light.
4.
Press the View button again to exit View mode. All input and
output buttons return to an unlit state.
DMS 1600 and DMS 3600 • Front Panel Operations
ENTER
9