Step 1: Installing The Fiber Modules - Fluke DTX-1800 Technical Reference Handbook

DTX Series CableAnalyzer
Technical Reference Handbook

Step 1: Installing the Fiber Modules

1-1 Turn off the tester and smart remote.
1-2 Remove the cover from the back of each unit and install
a DTX-MFM2, DTX-GFM2, or DTX-SFM2 module in each
unit, as shown in Figure 2-8.
Figure 2-8. Installing Fiber Modules
2-14
Leave the module bay covers in place when the
fiber modules are not installed.
Step 2: Checking the Battery Status and Verifying
Operation with Fiber Modules
2-1 Clean and inspect the tester's connectors and the
connectors on two SC/SC test reference cords. See page
8-9 for details on cleaning.
2-2 Connect the tester and smart remote together, as
shown in Figure 2-9.
2-3 Turn the rotary switch to SPECIAL FUNCTIONS.
D
2-4 Use
H
. Press
D
2-5 Use
P
2-6 Press
amd34af.eps
W
Caution
to highlight Battery Status; then press
I
when you are done.
to highlight Self Test; then press
to start the self test.
H
.