Accessing The Online Documentation; Updating The Optiview Workgroup Analyzer Firmware; Software Update Procedure; Step One - Update The Pc User Interface Software - Fluke OptiView III Series Getting Started Manual

Accessing the Online Documentation

This Getting Started Guide and Help are provided in electronic format on the OptiView Resource CD.

Updating the OptiView Workgroup Analyzer Firmware

To be notified when new software becomes available for your analyzer, or to access technical
support/knowledge base information via the web, please register your product at
http://support.flukenetworks.com.
From time to time, software improvements are being made to the analyzer. The software update involves
two steps; first to update the user interface software on the PC, then to individually update the firmware in
each of your OptiView Workgroup Analyzers to match the software version running on your PC.
You can obtain the latest version of software by visiting
to the PC that you intend to use to control your analyzers. This software is supplied to you on the OptiView
Resource CD that was shipped with your analyzer. To obtain additional CD copies or to get newer versions
supplied to you on a CD rather than downloading from our web site, see the section on Contacting Fluke
Networks Sales, Service, and Support Centers to make that request.

Software Update Procedure

Step One – Update the PC User Interface Software
Run the Launch.exe file on the OptiView Resource CD or within the download directory on your PC. The
InstallShield program will guide you through the steps that will install a new user interface on your PC or
TM
will update an existing user interface.
Updating the OptiView Workgroup Analyzer Firmware
Note
www.flukenetworks.com
Workgroup Analyzer
and downloading the file
17