Pinging Network Devices - Fluke DTX-1800 Technical Reference Handbook

Pinging Network Devices

The ping test verifies connectivity to devices on the
network.
To ping a network device:
1 Enter ping addresses in Setup. See page 11-4.
2 Connect to the network as shown on page 11-7.
3 Turn the rotary switch to MONITOR, select Network
Connectivity; then press
4 When the network connectivity test is complete, press
L
Ping.
P
.
Verifying Network Service
5 Do one of the following:
•
To ping one device, highlight the device; then press
P
.
•
To ping all devices in the list, press
The overall ping result appears on the Network
Connectivity screen. A scroll bar appears if you pinged
multiple devices
6 To see ping details (Figure 11-6), highlight a device;
H
then press .
7 To save the ping results, press
as part of the connectivity results. You can save the
network connectivity results in a separate record or
with an existing cable test record. See page 11-6.
Pinging Network Devices
J
Ping All.
N
. Ping results are saved
11
11-11