Wire Map - Fluke DTX-1800 Technical Reference Handbook

Wire Map

Wire map results show the connections between the main
and remote testers. The tester checks the cable pairs
required by the selected test limit. If the wire map test fails,
you can continue or stop the Autotest. Figure 3-10 describes
Correct wiring (568B)
Shield continuity is shown if a
shielded cable type (such as FTP or
SSTP) is selected in SETUP.
amd143i.bmp
Wire 3 is open 1.0 m from the tester
and 91.6 m from the smart remote.
Figure 3-10. Wire Map Examples
examples of wire map screens. For information on AC wire
map screens, see Chapter 4.
Tip: The wire map test in Single Test mode features a
scanning function that runs the wire map test
continuously. This function is helpful for locating
intermittent wiring faults.
amd144i.bmp
Open
Wires 1 and 2 are shorted 1 m from the
smart remote. Shorts not within a cable
pair are always show at the near end
(left side) of the wire map screen.
Certifying Twisted Pair Cabling
Twisted Pair Autotest Results
Short
3
amd81i.bmp
-continued-
3-15