Fluke DTX-1800 Technical Reference Handbook page 266

DTX Series CableAnalyzer
Technical Reference Handbook
To use the power meter in MONITOR mode:
If you need to save the power reading, use the
power meter function in the SINGLE TEST mode.
1 Clean the tester's input port, the test reference cord
connectors, and the source connector.
2 Use the test reference cord to connect the source to the
tester's input port, as shown in Figure 8-30.
3 Turn on the source.
Figure 8-30. Connections for Monitoring Optical Power (MONITOR mode)
8-58
Note
4 Turn the rotary switch to MONITOR; then select Power
Meter.
P
5 Press .
6 Select the appropriate wavelength; then press
power meter in MONITOR mode runs continuously
I
until you press .
Figure 8-31 describes the power meter screens for SINGLE
TEST and MONITOR modes.
P
. The
amd126f.eps