1564 Barcode Scanner
1.6.6 ALTERNATE MODE
The scanner will start scanning once the trigger is pressed
The scanning won't stop until you press the trigger again.
1.6.7 AIMING MODE
The scanner will aim at a barcode once the trigger is pressed, and start scanning when
the trigger is pressed again within one second.
The scanning won't stop until (1) a barcode is decoded, and (2) the pre-set timeout
expires.
Aiming Timeout
You can limit the aiming time interval (1~15). By default, the scanner time-out is set to 1 second.
1.
Read the barcode above to specify the time interval before aiming ends. (It is set to 1 by
default.)
2.
Read the
"Decimal
to automatically shut down after being idle for 10 seconds.
3.
Read the "Validate" barcode on the same page to complete this setting.
40
User Guide
Value" barcode on page 251. For example, read "1" and "0" for the scanner
Alternate Mode
Aiming Mode
Aiming Time-out
after 1~15 sec.
(*1)
Enter Setup