Change Interface - CipherLab 1663 User Manual

3.1.2 CHANGE INTERFACE

If you want to change the communication interface of 3610, use one of the connected
scanners to configure the interface-related settings and the scanner will pass the new
settings to 3610, which will then initialize and pass the settings to other connected
scanners.
1) Read the "Set Connection" and "Serial Number" barcodes at the back of 3610.
2) Within two minutes, connect 3610 to the USB port of PC. For USB Virtual COM, you
will need to install its driver first!
3) Scanners will connect to the computer via 3610.
4) Read the "Enter Setup" barcode to enter the configuration mode.
5) Read the desired interface barcode and configure its related settings –
"Activate USB HID & Select Keyboard Type"
"Activate USB Virtual COM"
6) Read the "Update" barcode to exit the configuration mode.
7) After the scanner resumes connection with 3610, it will pass the interface-related
settings to 3610.
8) Upon receipt of the new settings, 3610 will initialize itself.
9) Updated with new settings, 3610 will pass the settings to other connected scanners.
Chapter 3 Set up a WPAN Connection
Update
99