Show Tech-Support Mpls Ldp - Cisco ASR 9000 Series Command Reference Manual

show tech-support mpls ldp

show tech-support mpls ldp
To automatically run show commands that display information specific to Multiprotocol Label Switching
(MPLS) Label Distribution Protocol (LDP) debugging, use the show tech-support mpls ldp command in
EXEC mode.
show tech-support mpls ldp {file send-to [background] [compressed| uncompressed]| terminal [page]|
location node-id}
Syntax Description
file
send-to
background
compressed
uncompressed
terminal
page
Cisco ASR 9000 Series Aggregation Services Router Advanced System Command Reference, Release 4.0
156
Specifies that the command output is saved to a specified file.
Name of the file. The following valid options are listed:
• filename
• bootflash: filename
• disk0: filename
• disk0a: filename
• disk1: filename
• disk1a: filename
• ftp: filename
• harddisk: filename
• harddiska: filename
• harddiskb: filename
• nvram: filename
• rcp: filename
• tftp: filename
(Optional) Specifies that the command runs in the background.
(Optional) Displays compressed command output.
(Optional) Displays the command output with no compression.
Specifies that the command output is displayed on the terminal.
(Optional) Specifies that the command output is displayed one page at a time.
Use the return key to display the next line of output or use the space bar to display
the next page of information. If not used, the output scrolls (that is, it does not
stop for page breaks).
Press the Ctrl+C keys to stop the command output.
Tech-Support Commands