Configure Mpls Ldp Nonstop Routing - Cisco ASR 9000 Series Configuration Manuallines

Configure MPLS LDP Nonstop Routing

Example:
RP/0/RSP0/CPU0:router (config-l2vpn)# nsr
Enables L2VPN nonstop routing.
Step 4
logging nsr
Example:
RP/0/RSP0/CPU0:router (config-l2vpn)# logging nsr
Enables logging of NSR events.
Step 5 Use the commit or end command.
commit - Saves the configuration changes and remains within the configuration session.
end - Prompts user to take one of these actions:
• Yes - Saves configuration changes and exits the configuration session.
• No - Exits the configuration session without committing the configuration changes.
• Cancel - Remains in the configuration mode, without committing the configuration changes.
Configure MPLS LDP Nonstop Routing
Perform this task to enable Label Distribution Protocol (LDP) Nonstop Routing (NSR) for synchronizing
label information between active and standby LDPs. From Release 6.1.1 onwards, with the introduction of
stateful LDP feature, you must explicitly configure LDP NSR to synchronize label information between active
and standby LDPs.
SUMMARY STEPS
1. configure
2. mpls ldp
3. nsr
4. Use the commit or end command.
DETAILED STEPS
Step 1 configure
Example:
RP/0/RSP0/CPU0:router# configure
Enters Global Configuration mode.
Step 2
mpls ldp
Example:
L2VPN and Ethernet Services Configuration Guide for Cisco ASR 9000 Series Routers, IOS XR Release 6.3.x
150
Implementing Point to Point Layer 2 Services