Cisco ASR 9000 Series Command Reference Manual page 257

Tech-Support Commands
Command Default
The command output is not compressed.
Command Modes
EXEC
Command History
Release
Release 3.7.2
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
This command can generate a very large amount of output. You may want to redirect the output to a file
Tip
using the file send-to keyword and argument. Redirecting the output to a file also makes sending the
output to your Cisco Technical Support representative easier.
Use the show tech-support routing rpl command to run show commands that display information specific
to RPL debugging. This command generates RPL debugging information that can be useful for Cisco Technical
Support representatives when troubleshooting a router. See 'Obtaining Documentation and Submitting a
Service Request' section on page iii in the Preface for Cisco Technical Support contact information.
Note This command is not required during normal use of the router.
The following show commands run automatically when you run the show tech-support routing rpl
command:
• show running-config rpl
• show process policy_repository
• show rpl route-policy policy-name pxl
• show sysdb reg notif path /ipc/gl/policy_lang/policies/routing/ policy-name /pxl s
See the Cisco IOS XR software command references for information about these commands and descriptions
of their command output. The Cisco IOS XR software command references are located at the following URL:
http://www.cisco.com/en/US/products/ps5845/prod_command_reference_list.html
Task ID
Task ID
basic-services
Cisco ASR 9000 Series Aggregation Services Router Advanced System Command Reference, Release 4.0
Modification
This command was introduced.
Operations
read
show tech-support routing rpl
251