Cisco ASR 9000 Series Command Reference Manual page 118

show tech-support ethernet
The command output is compressed.
Command Modes
EXEC
Command History
Release
Release 3.7.2
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Tip This command can generate a very large amount of output. You may want to redirect the output to a file
using the file send-to keyword and argument. Redirecting the output to a file also makes sending the
output to your Cisco Technical Support representative easier.
Use the show tech-support ethernet command to run show commands that display information specific
to VLAN and ethernet infrastructure debugging. This command generates ethernet debugging information
that can be useful for Cisco Technical Support representatives when troubleshooting a router. See 'Obtaining
Documentation and Submitting a Service Request' section on page iii in the Preface for Cisco Technical
Support contact information.
This command is not required during normal use of the router.
Note
The following show commands run automatically when you run the show tech-support ethernet command:
• show version
• show running
• show route {ipv4 | ipv6} unicast
• show proc blocked
• show ethernet {ipv4 | ipv6 | mpls} exceptions
• show ethernet {ipv4 | ipv6 | mpls} drop
• show ipv4 interface brief
• show mpls forwarding (if the mpls keyword is specified)
See the Cisco IOS XR software command references for information about these commands and descriptions
of their command output. The Cisco IOS XR software command references are located at the following URL:
http://www.cisco.com/en/US/products/ps5845/prod_command_reference_list.html
Cisco ASR 9000 Series Aggregation Services Router Advanced System Command Reference, Release 4.0
112
Modification
This command was introduced.
Tech-Support Commands