Cisco ASR 9000 Series Command Reference Manual page 94

show tech-support cef
Command Default
IPv4 is the default.
The command output is not compressed.
Command Modes
EXEC
Command History
Release
Release 3.7.2
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
This command can generate a very large amount of output. You may want to redirect the output to a file
Tip
using the file send-to keyword and argument. Redirecting the output to a file also makes sending the
output to your Cisco Technical Support representative easier.
Use the show tech-support cef command to run show commands that display information specific to CEF
debugging. This command is used to locate any issues related to the Forwarding Information Base (FIB)
which is more commonly referred to as Cisco Express Forwarding (CEF). This command generates CEF
debugging information that can be useful for Cisco Technical Support representatives when troubleshooting
a router. See 'Obtaining Documentation and Submitting a Service Request' section on page iii in the Preface
for Cisco Technical Support contact information..
This command is not required during normal use of the router.
Note
The following show commands run automatically when you run the show tech-support cef command:
• show version
• show running
• show route {ipv4 | ipv6} unicast
• show proc blocked
• show cef {ipv4 | ipv6 | mpls} exceptions
• show cef {ipv4 | ipv6 | mpls} drop
• show ipv4 interface brief
• show cef {ipv4 | ipv6} summary
• show cef {ipv4 | ipv6 | mpls} interface
Cisco ASR 9000 Series Aggregation Services Router Advanced System Command Reference, Release 4.0
88
Modification
This command was introduced.
Tech-Support Commands