Cisco ASR 9000 Series Command Reference Manual page 152

show tech-support lrd
node-id
all
rack
Command Modes
EXEC
Command History
Release
Release 3.7.2
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
This command can generate a very large amount of output. You may want to redirect the output to a file
Tip
using the file send-to keyword and argument. Redirecting the output to a file also makes sending the
output to your Cisco Technical Support representative easier.
Use the show tech-support lrd command for the LRD debugging, which controls the Secure Domain Router
(SDR) architecture. The system always has at least one SDR at any time. It collects relevant information when
issues arise with the SDR management within the system. This command can be useful for Cisco Technical
Support representatives when troubleshooting a router. See 'Obtaining Documentation and Submitting a
Service Request' section on page iii in the Preface for Cisco Technical Support contact information.
Note This command is not required during normal use of the router.
See the Cisco IOS XR software command references for information about these commands and descriptions
of their command output. The Cisco IOS XR software command references are located at the following URL:
http://www.cisco.com/en/US/products/ps5845/prod_command_reference_list.html
Task ID
Task ID
cisco-support
Cisco ASR 9000 Series Aggregation Services Router Advanced System Command Reference, Release 4.0
146
(Optional) Node ID. The node-id argument is entered in the rack/slot/module
notation.
(Optional) Specifies all locations.
(Optional) Displays the list of racks.
Modification
This command was introduced.
Tech-Support Commands
Operations
read