Show Tech-Support Mpls Ldp - Cisco XR 12000 Reference

Tech-Support Commands

show tech-support mpls ldp

To automatically run show commands that display information specific to Multiprotocol Label Switching
(MPLS) Label Distribution Protocol (LDP) debugging, use the show tech-support mpls ldp command in
EXEC mode.
show tech-support mpls ldp {file send-to [background] [compressed| uncompressed]| terminal [page]|
location node-id}
Syntax Description
file
send-to
background
compressed
uncompressed
terminal
page
OL-30353-01
Specifies that the command output is saved to a specified file.
Name of the file. The following valid options are listed:
• filename
• bootflash: filename
• disk0: filename
• disk0a: filename
• disk1: filename
• disk1a: filename
• ftp: filename
• harddisk: filename
• harddiska: filename
• harddiskb: filename
• nvram: filename
• rcp: filename
• tftp: filename
(Optional) Specifies that the command runs in the background.
(Optional) Displays compressed command output.
(Optional) Displays the command output with no compression.
Specifies that the command output is displayed on the terminal.
(Optional) Specifies that the command output is displayed one page at a time.
Use the return key to display the next line of output or use the space bar to display
the next page of information. If not used, the output scrolls (that is, it does not
stop for page breaks).
Press the Ctrl+C keys to stop the command output.
Cisco IOS XR Advanced System Command Reference for the Cisco XR 12000 Router, Release 5.1.x
show tech-support mpls ldp
249