Table of Contents
Advertisement
6.6 Configuring the Web Server
IMPORTANT:
The Web Server opens
The moisture.IQ can be remotely accessed using a web browser by enabling the Web Server. To configure the
Server
, complete the following steps:
1. From the Configuration Menu screen (see Figure 52 on page 57), tap the
Server Setup screen similar to Figure 73 below.
Web Server
2. If the
Server (changes to the settings can only be made when the
Port
3. Tap the
button and enter the appropriate Port Number. Then, tap the
Return
the
button to return to the Web Server Setup screen. In most cases, the default
Web Server
4. Tap the
5. After the Web Server status has been configured as desired, tap the
Menu.
When the Web Server is
moisture.IQ User's Guide
Port 80
when it is
Figure 73: Web Server Setup Screen
button indicates that the Web Server is currently
button so that it indicates that the server is either
Enabled
, it can be used to monitor the instrument status and to perform file downloads.
Enabled
.
Enabled
Web Server
Enabled
Return
Chapter 6. Setting Up Communications
Web Server
button to open a Web
Disable
, tap this button to
Disabled
is
).
Check
button to save the value and tap
Port 80
should be used.
Disabled
or
, as desired.
button to return to the Configuration
Web
the Web
81
Advertisement
Table of Contents
