Table of Contents
Advertisement
Chapter 2. Operation
2.1 Powering Up
After completing the installation of your system, as described in Chapter 1. "Installation and Wiring" on page 1,
power up the moisture.IQ with the
the following display screens in sequence:
1. A black screen with a large GE monogram in the center.
2. A black screen with a GE monogram and the "moisture.IQ" name, along with a blue progress bar along the
right edge of the screen.
3. A measurement display screen, similar to that shown in Figure 27 below.
Note: The moisture.IQ is equipped with an automatic cooling fan. This fan will activate as needed to maintain the
proper temperature inside the enclosure. The periodic sound of this fan running is normal.
2.2 Measurement Display Components
The measurement display screen shown in Figure 27 above is a touch screen which includes the following items:
•
Either 6 or 12 measurement displays per screen (depending on your display configuration settings)
•
The main menu for programming the moisture.IQ, consisting of the 6 options shown
•
Left and Right arrows, with a page number between them, which are used to scroll through the pages of
measurement displays (6 pages of 6 measurements/page or 3 pages of 12 measurements/page)
To access any of the screen components, simply tap on the desired item with your finger tip.
moisture.IQ User's Guide
ON/OFF
switch located at the lower left corner of the back panel. You will observe
Figure 27: Measurement Display Screen
Chapter 2. Operation
31
Advertisement
Table of Contents
