Chapter 4. Using the Outputs, Alarms and Logger Menus
4.2.2 Testing the Selected Alarm
Complete the following steps to test the alarm:
Channel (1-6)
1. Tap the
Figure 48 below.
Trip
2. Tap the
button to trip the alarm and verify that the alarm has been tripped.
Reset
3. Tap the
button to reset the alarm and verify that the alarm has been reset.
4. After you have finished testing the alarm, tap the
52
Alarm
A
B
and
(
or
) to be tested, and then tap the
Figure 48: Alarm Test Screen
Test
Exit
button to return to the Alarm Selection screen.
button to open a screen similar to
moisture.IQ User's Guide