Adapting An Existing Tf-Series Probe Cable - GE moisture.IQ User Manual

Chapter 1. Installation and Wiring

1.8.2 Adapting an Existing TF-Series Probe Cable

If an existing moisture measurement system uses a
MISP2
for use with an probe. To retrofit the existing system, refer to Figure 5 below and complete the following steps:
1. Locate the existing
TF-Series
2. Replace the
3. Using GE adapter cable 704-1362-00, shown in Figure 5 above, connect one end of the cable to the
probe and connect the other end to the existing
4. At the moisture analyzer end of the
leads from the pluggable connector.
BLACK
5. Locate the
probe grey pluggable connector. See "Moisture Image Series Probes (MISP and MISP2)" on page 19 for help.
6. Trim all other flying leads from the
7. Plug the newly-wired
10
MISP2 Connector
[Total Cable Length = 6.50"]
Figure 5: TF-MISP2 Converter Cable
TF-Series
probe and disconnect the cable from the probe.
MISP2
probe with an
TF-Series
WHITE
and wires of the
TF-Series
MISP2
probe pluggable connector into the moisture.IQ.
TF-Series
moisture probe, the cable for that probe may be adapted
TF Connector
probe.
TF-Series
cable connector.
cable, locate the same
TF-Series
cable and connect them to the moisture.IQ at the
cable flush with the jacket.
TF-Series
cable and disconnect all flying
moisture.IQ User's Guide
MISP2
MISP2