Table of Contents
Advertisement
1.9.3b
Moisture Image Series Probes (MISP and MISP2)
Connect the Moisture Image Series probes (
Moisture Image Series probe up to 915 m (3000 ft) from the electronics unit.
Before making any electrical connections, you must assemble the probe. A Moisture Image Series probe may be
probe
shipped in two parts: a
than one probe, be sure to match each probe to its matching electronics module using the serial numbers listed on the
probe Calibration Data Sheet. To assemble a Moisture Image Series probe, insert the probe into the probe connector on
the matching electronics module and turn the probe counterclockwise until it locks in place (see Figure 14 below).
CAUTION! The MISP2 probe has an integral set of electronics permanently attached (see Figure 15
below). Do not attempt to separate an MISP2 probe from its electronics.
moisture.IQ User's Guide
MISP
) to the moisture.IQ using the cable provided. You can locate a
electronics module
and an
Connector
Figure 14: Moisture Image Series Probe (MISP) Assembly
Figure 15: MISP2 Probe
, each of which has its own serial number. If you ordered more
Chapter 1. Installation and Wiring
19
Advertisement
Table of Contents
