Table of Contents
Advertisement
5.4.2 Entering User-Defined Tables
To support user-defined functions, the moisture.IQ allows up to six user-defined tables (designated as
Table F
) of non-linear or empirical data. Up to 10
value, the meter interpolates the corresponding
X
extrapolated if the
value exceeds the range of the table.)
From the Configuration Menu screen (see Figure 52 on page 57), tap the
screen similar to Figure 62 below.
To set up a user table, complete the following steps:
1. Tap the button at the upper left of the screen to select the table name (
drop-down list.
2. The table may contain from 2-10 rows. Use the
the desired number of rows.
3. To enter or edit the data in the table, tap the desired table cell to highlight it in blue. Then, tap the
button to enter the data for that cell. Repeat this process until all of the data has been entered.
Note: The
Copy
Paste
and
4. After all of the data has been entered, tap the
X
order of
values. Then, tap the
Configuration Menu.
moisture.IQ User's Guide
X-Y
Y
value and outputs that value to the function. (The results are
Figure 62: User Table Setup Screen
buttons can be used to copy data from another table into this new table.
Check
button to save the table and tap the
pairs can be entered in each table. If a user function inputs an
Tables
Insert Row
Delete Row
and
Sort
button to be sure the data points are arranged in ascending
Chapter 5. Using the Configuration Menu
button to open a User Table Setup
Table A
Table F
through
) from the
buttons to configure the table with
Return
button to return to the
Table A
through
X
Edit Value
69
Advertisement
Table of Contents
