Table of Contents
Advertisement
Chapter 5. Using the Configuration Menu
5.4.4 Entering Saturation Constants (cont.)
Chemical
4. Select the
5.
Repeat steps 2-4 until all of the data has been entered. After you select
Note: At least 90% of the total composition must be entered. For any compositions that total less than 100%, each
chemical will be extrapolated to bring the total to 100%.
5.4.4a
Entering Saturation Constants Manually
To manually enter the Cs values for your application, complete the following steps:
Manual Entry
1. Select
Channel
2. Tap the
Insert Row
3. Use the
4. To enter or edit the data in the table, tap the desired table cell to highlight it in blue. Then, tap the
button to enter the data for that cell. Repeat this process until all of the data has been entered.
Note: The
Copy
Paste
and
5.
After all of the data has been entered, tap the
order of Temp C values. Then, tap the
Configuration Menu.
72
and enter its percentage of the overall composition.
Figure 66: Entering Constants Manually
.
button and specify the channel for which the Cs curve should be applied.
Remove Row
and
buttons to configure the table with up to 10 rows.
buttons can be used to copy data from another table into this new table.
Check
Sort
button to be sure the data points are arranged in ascending
button to save the table and tap the
Save
, the Cs Table will appear.
Return
button to return to the
moisture.IQ User's Guide
Edit Value
Advertisement
Table of Contents
