Table of Contents
Advertisement
Chapter 4. Using the Outputs, Alarms and Logger Menus
4.1 Setting Up the Outputs
4.1.1 Configuring an Output
Note: An active output is indicated by a "Play" symbol, and the alarm selected for editing is highlighted in yellow. A
dashed border around an output indicates that the channel is not installed.
The moisture.IQ features two isolated analog outputs (A and B) for each of its six channels. To configure these outputs,
refer to the menu map in Figure 77 on page 108 and tap the
open a screen similar to that shown in Figure 43 below.
1. Tap the button for the desired
2. In the Measurement Selection section, tap the
desired settings for the output. (For available modes and units, refer to Table 8 on page 59.)
Zero
3. Tap the
box and enter the zero value via the keypad.
Span
4. Tap the
box and enter the span value via the keypad.
Check
5. Tap the
button to save your settings.
moisture.IQ User's Guide
Outputs
Figure 43: Outputs Selection Screen
Channel
Output
(1-6) and
Mode, Unit
Chapter 4. Using the Outputs, Alarms and Logger Menus
button on the right side of the main touch screen to
A
B
(
or
).
Type
and
(Current or Voltage) buttons to enter the
47
Advertisement
Table of Contents
