Adapting An Existing M-Series Probe Cable - GE moisture.IQ User Manual

1.8.3 Adapting an Existing M-Series Probe Cable

If an existing moisture measurement system uses a
MISP2
for use with an probe. To retrofit the existing system, refer to Figure 6 below and complete the following steps:
1. Locate the existing
M-Series
2. Replace the
3. Using GE adapter cable 704-1649-00, connect one end of the cable to the
end to the existing
4. At the moisture analyzer end of the
leads from the pluggable connector.
GREEN
5. Locate the
MISP2
probe grey pluggable connector. (The
RED
wire is connected to the
MISP2)" on page 19 for help.
6. Trim all other flying leads from the
7. Plug the newly-wired
moisture.IQ User's Guide
MISP2 Connector
[Total Cable Length = 6.50"]
Figure 6: M-MISP2 Converter Cable
M-Series
probe and disconnect the cable from the probe.
MISP2
probe with an
M-Series
cable connector.
M-Series
RED M-Series
and wires of the
MISP
connector "
M-Series
MISP2
probe pluggable connector into the moisture.IQ.
M-Series
moisture probe, the cable for that probe may be adapted
M Series Connector
probe.
cable, locate the same
cable and connect them to the
GREEN
wire is connected to the
WHT
" label.) See "Moisture Image Series Probes (MISP and
cable flush with the jacket.
Chapter 1. Installation and Wiring
MISP2
probe and connect the other
M-Series
cable and disconnect all flying
BLACK WHITE
and
MISP
connector
wires at the
"BLK"
label and
11