Downloading Netbackup Client Packages To A Client From A Netbackup Appliance - VERITAS NetBackup 5330 Configuration Manual

Downloading NetBackup client packages to a
client from a NetBackup Appliance

Downloading NetBackup client packages to a client from a NetBackup Appliance

To change the IP address for NIC1 (eth0) after the initial configuration has been
completed, do one of the following:
From the NetBackup Appliance Web Console
■
After logging into the appliance, click Settings > Network > Network Settings.
In the Network Configuration section, edit the IPv4 address setting for NIC1
(eth0).
For more information, see the NetBackup Appliance Administrator's Guide.
From the NetBackup Appliance Shell Menu
■
After logging into the appliance, use the
the IP address for NIC1 (eth0).
For more information, see the NetBackup Appliance Command Reference Guide.
Note: If NIC1 (eth0) is not configured on your appliance, checkpoint operations
do not work from the NetBackup Appliance Web Console. This issue occurs
only if you have removed the IP address configuration for the port. If you
encounter this issue, configure the port or use the NetBackup Appliance Shell
Menu to create a checkpoint or to roll back to one. As a best practice, even if
NIC1 (eth0) is not used, make sure that it is configured with an IP address.
You can download NetBackup client software from a NetBackup Appliance to any
client that you want to back up. The NetBackup Appliance Web Console logon page
provides a Download Packages section to download the client packages.
The packages are listed by operating system type in a drop-down box as follows:
All
■
Windows
■
Linux
■
Solaris
■
AIX
■
HP
■
BSD
■
Mac OS
■
Post configuration procedures
command to change
Network > IPv4
56